60
AUX, MTX, MAIN operations
AUX, MTX, MAIN operations
MTX SENDS (AUX, MAIN only)
fig.ScrMtxSends.eps
Here you can adjust the sends from the AUX1–8 or MAIN L/
R/C to the MTX1–4.
●
MTX sends 1––4
The MTX send area is structured as follows:
fig.ScrMtxSendField.eps
MTX number
This indicates the MTX number.
MTX name
This indicates the MTX name.
Send level bar
This adjusts the send level to each MTX in a range of -Inf dB–
+10.0dB.
The color of the level bar indicates the send point or status of
the send switch as follows:
●
MTX pan slider
fig.ScrMtxSendField2.eps
If the send-destination is a stereo-linked pair of MTX, this
slider adjusts the left/right position in a range of L63–R63.
This is shown for the odd-numbered MTX send.
For detailed MTX send settings, refer to “p. 86”.
TO MAIN (AUX only)
fig.ScrChMainSend.eps
These specify the amount of signal that will be sent from the
AUX to MAIN.
LCR button
This button specifies how signals are sent from the AUX to
MAIN L/R and MAIN C.
* The MAIN button appears at the position of LR button and C
button when the LCR button is turned on.
MAIN button
This turns the send to MAIN L/R/C. This is shown only when
the LCR button is on.
LR button / C button
These individually turn the send to the MAIN L/R and MAIN C
on/off. These are shown only when the LCR button is on.
CENTER
This specifies the proportion of the signal that is sent to
MAIN C when PAN is at C (center) as a value in a range of
0%–100%
.
This is valid when the LCR button is on.
fig.Pan_LCR.eps
Color of the send
level bar
Status
Blue
send point is PRE EQ or PRE FADER
Green
send point is POST FADER
Gray
Send switch is off
5
1
2
3
1
2
3
LCR
button
Explanation
OFF
The signals sent to MAIN L/R and MAIN C can be
individually turned on/off by using the LR button and C
button.
ON
PAN will operate across the three outputs MAIN L,
MAIN C, and MAIN R. The convergence of the sound to
MAIN C can be adjusted by CENTER. The signals sent to
MAIN L/R and MAIN C can be collectively turned on/off
by the MAIN button.
*
CENTER Explanation
0%
No signal will be sent to MAIN C.
100%
When PAN is set to C, the signal will be sent only to MAIN
C.
6
1
2
4
5
3
1
2
3
4
L
C
PAN
LEVEL
R
t
o
LE
F
T
t
o
RI
G
H
T
Center 0%
L
C
PAN
LEVEL
R
to
L
EF
T
t
o
R
I
GH
T
to C
E
N
T
E
R
Center 50%
L
C
PAN
LEVEL
R
t
o
L
E
F
T
t
o
R
IG
H
T
to
CE
N
TE
R
Center 100%
M-300_e.book 60 ページ ２０１０年４月２２日 木曜日 午前８時１７分
