Instructions for Mini Lite Installation
1.
Mount Mini Lite so antenna cable, USB Ports and HDMI Cable are accessible.
2.
Connect satellite antenna to Mini Lite receiver.
3.
Connect HDMI cable from Mini Lite to TV.
4.
If using the supplied Y cable for power, remove existing power cable from TV and plug
into the female end of the T cable, then plug male ends into TV and Mini Lite.
5.
Plug IR sensor into IR socket on the side. Mount IR sensor to front side of TV or wher-
ever you can point the remote to.
6.
Turn TV on with the TV remote and select HDMI input.
7.
Turn the Mini Lite on with the Mini Lite remote and select channel to view.
CAUTION - PLEASE NOTE: Should you be disconnecting and/or reconnecting the satellite dish lead
please ensure the Receiver is turned OFF. This will prevent any short circuit on the LNB supply voltage
from the Receiver. Also ensure there is no faults on the aerial lead and any dish connections are cor-
rect. RSE will not cover any warranty where LNB output has been damaged.
CONDITIONS OF SALE:
RSE accepts no warranty on the availability of channels from any satellite network.
From time to time channel lists and programs change, this may require you to have this receiver reprogrammed
or set up with new software. This may require a technicians visit, website access or sending this unit back to
RSE in Auckland for programming. Some of the above will incur charges which would be the responsibility of
the customer to pay.
RSE does not accept any warranty on the services provided other than hardware failure.
Channels as of March 2019
1
5
9
13
17
2
6
10
14
18
3
7
11
15
19
4
8
12
16
20
1
2
3
4
5
