Introduction
The remote keypad is an electronic switching device which can
be fitted as an accessory for the Advantage 6 control panel and
has been designed to fit into a single gang back pattress (not
supplied), which can be either flush or surface mounted.
The remote keypad can be wired using a 4-core cable (if the
tamper circuit is not required), or wired with 6-core cable if a
tamper circuit is required between the main control panel and
the remote keypad. The unit has been designed simply to arm,
disarm and part-arm the system. It is not possible to change
the systems programs using the remote keypad.
The remote keypad is supplied with an attractive white finishing
plate to blend in with existing surroundings the remote keypad
is also back illuminated to facilitate ease of use during evening
time or when fitted in dark areas. Up to 6 keypads can be used
on one panel.
Installation
We recommend that before beginning the installation work
these instructions are read carefully.
Note:
DO NOT USE A METAL PATTRESS.
Position the remote keypad at a height that allows ease of use.
The same height of a light switch would be suitable, run a 4 or
6-core cable (if tamper is in use) from the main control panel to
the remote keypad, taking care not to run the cable adjacent to
mains (230V) cable, feed the cable into the pattress and then
secure the pattress to the wall.
At the control panel
1.
Isolate the panel from the mains supply.
2.
Type in your engineer code.
3.
Unscrew the front cover of the alarm panel.
4.
If your alarm has a sounder with SAB unit fitted it is
advisable to disconnect the SAB battery.
5.
Disconnect the battery from the alarm panel.
6.
Connect the small driver board as shown in figure 1.
7.
Now connect the keypad as shown in figure 2.
Note:
If you use the 24 hour tamper circuit you need to
connect the keypad in series with the other
devices connected in the circuit.
8.
If more than one keypad is required then the connections
should be made in parallel apart from the 24 hour tamper
circuit that should be connected in series.
Advantage 6 Remote Keypad
Stock No. 437-654
Figure 1. Driver board connection
RT
SWITCHED POSITIVE
STROBE -
BELL +
BELL -
SPEAKER
NVM RESET
BELL / STROBE F3
SPEAKER
AUX. F2
BATTERY F1
AUX +
AUX -
B RED
BATTERY - BLACK
AC
AC
TRANSFORMER
SCB
24 hour
KEYSWITCH
PA
ZONE 6
ZONE 5
ZONE 4
ZONE 3
ZONE 2
ZONE 1
(Entry/Exit)
SA12
SA12
SA12
4001
+12
6
0V
7
SP-
13
KS
21
TAMP
14 15
220uF +
220uF +
78L05
PB
Tamper
switch
Figure 2. Keypad panel connections
A
B
A. Driver board
B. Alarm panel
PCB
Remote keypad and
control panel connections