Documenting Multifunction Calibrator / EN
06/04/2018 Version No. 1
25
8. Current Input (Measure)
8a-1. -4mA ~ 24mA
(1) Turn on the power. Turn sliding switch to mA.
(2) Press
button to select MEASURE (input) mode.
(Press
to set the OUTPUT mode as SIMULATE.)
(3) Connect Test leads or Alligator clips to MEASURE terminals (red to +,
and black to -).
(4) Then connect the other ends of Test leads or Alligator clips to the object
for measurement.
(5) The calibrator display will show the measurement result.
(6) Data logging function: refer to
“Data logging” chapter.
Remark: 1.
The measurement result is 5-digit (including decimal point and
negative sign).
Warning: 1.
Perform one function at a time and make connection to the
specific terminals only. Remove all other connections to the unused terminals.
Always connect to only one of SOURCE , MEASURE , or TC alone.