RR Mechatronics STARRSED RS, User Manual

Page: 98 / 259

6.7.1.3.1 - Set as tube 1 position
This section is used to make sure the needle sting position is centered in with the hole in the top bracket.
Perform the following steps for checking the needle sting location:
1. Go to
Tube position number
1.
2. Press outer needle
DOWN
.
3. Check the needle position.
4. Continue to press the needle
DOWN
and visually check the needle goes through the hole in the top of
the bracket.
5. Press outer needle
UP
.
If the needle is not passing the hole, see Tube not in 1 position .
6.7.1.3.2 - Test position motor
Perform the following steps to test the position motor:
1. Go to
IN position
: This is the position where the rack clamp is open. The rack can be inserted manually
in the clamp.
2. Go to
MIX position
: This is the rotation position where the rack clamp is engaged to secure the rack for
mixing the sample tubes.
3. Go to
(1)TUBE position
: This is the first hole position in the grabber cover plate at the needle position.
4. Go to
RELEASE position
: This is the position for releasing the rack. The grabber will be opened and the
rack is transported to the Rack out position.
Go to position
: Service purpose only (This is to move from the home position to any distance in millimeters
from the home position).
6.7.1.3.3 - Select rack
Select the required rack adapter what is used on the instrument.
The following rack types can be selected:
• Sysmex:
Low profile with multi tube holders
Low profile with clips
Low profile with clips and barcode id plates
• Coulter
• Coulter short
• Abbot long, black
• Bayer (advia)
• Abbot Short, white
Starrsed program
98
MRN-071-2-EN version 7.02 Starrsed RS