RPM Systems Corporation
March, 2016 Page 9
MPQ Manufacturing Programmer User's Guide
valid. The "Load Image from File" dialog box will then appear. In this dialog box, you will name the image and
select the programming parameters which will be stored with this image in programmer Flash. (Note: if you
"Cancel" the file browse box without selecting an image, the Load Image from File dialog will open with an
empty image file
n
a
m
e
)
.
2.4.1 Selecting Programming Parameters
The Load Image dialog allows you to name the new image and to select other parameters necessary for
the programmer to properly program devices.
The Image Name is purely for user convenience. It is stored with the image in Flash, and is intended to
help you identify the image. The Image Name defaults to the name of the .hex image file, but could be changed,
for instance, to indicate the part number and revision of the firmware.
Once the Load Image dialog is open, you may choose a different image file by clicking on the ellipses next
to the Image File. This will reopen the file browse box.
The Image Number shown in the Load Image dialog is the number of the image bank selected in the Image