12
3 Before use
3
Before use
3.1 Unpacking
1.
Unpack the appliance and its accessories (Fig. 1).
2.
Check that the contents are intact.
3.2 Filling the water tank
1.
If the appliance was previously in operation:
1. Pull out the plug after use.
2. Discharge the steam by pressing the steam button.
3. Allow the appliance to cool down for approx. 30 mins.
4. Screw open cap.
If the cap still will not open after steps 1.1–1.4, push down the red pin
in the cap.
2.
Screw the tank cap counter-clockwise off the water tank (Fig. 3).
3.
Fill the included filling container with cold, clear tap water up to the 0.7
litre mark.
4.
Put the supplied funnel into the opening of the water tank (Fig. 4/A).
5.
Fill the water tank by emptying the refilling container into the funnel
(Fig. 4/B).
6.
Fill the refilling a second time and slowly and carefully pour its contents
into the water tank.
7.
Refit the tank cap and fasten it by turning clockwise (Fig. 5). Check that
it is securely fitted.
ATTENTION:
Always transport or ship the appliance in its original packaging to avoid
damage. Keep the packaging for such an event. However, dispose of no
longer needed packaging material properly.
NOTE:
Immediately contact your dealer if you have found damage resulting
from transport.
Danger of scalding!
Only open the cover
after the appliance
has cooled off.
Read the operating
manual before using
the appliance.
2
3
A
B
4
5
WARNING:
Danger of electric shock! Never fill an appliance with water when it is
connected to the mains.
WARNING:
Danger of injury! Use no additives such as cleansers, alcohol, perfumes
or chemicals in your water. These make the use of the appliance unsafe.
WARNING:
Risk of scalding! The water tank is under pressure as soon as the appli-
ance is switched on. Even after disconnecting the appliance from the
mains, steam pressure may remain:
1. Pull out the plug after use.
2. Discharge the steam by pressing the steam button.
3. Allow the appliance to cool down for approx. 30 mins.
4. Screw open cap.
If the cap still will not open after steps 1–4, push down the red pin in the
cap. Only then can you unscrew the tank cap and fill the water tank as
follows.
WARNING:
Risk of burns! The tank cap and the appliance parts in its proximity might
still be hot. To refill it, use the funnel and refilling container supplied only.
NOTE:
The service life of the appliance can be extended by using distilled water
instead of tap water. This is especially recommended in areas with hard
water.
NOTE:
Do not overfill the tank. Be aware of any residual water in the tank.
WARNING:
Risk of scalding! Only operate the appliance if the tank cap is securely
screwed on.
Vaporex.book Seite 12 Freitag, 8. Juli 2011 9:56 09
