Sigmont 65H
9
1. Turn the power switch on (“I” position). The power switch is located on the rear left side of the unit.
2. Complete the steps as in the “LOADING FILM” section.
3. Load the roll of material to be laminated onto the bottom film supply shaft. Center with the laminate on the upper
film shaft by using the centering markers supplied on the film shaft.
4.
Open the laminator rollers. Please refer to Section 10: Adjusting the space of both rollers.
5.
Bring you material on the bottom supply shaft that needs to be laminated over the laminator feed table and slightly
into the open rollers.
6. Run you laminate from your upper supply shaft below the top idle bar and around the top laminator roller
so that it is past the laminator roller nip position.
7.
Close the laminator rollers together by using the Nip Adjustment Wheel
8. Separate the laminate release liner from the laminate and tape to the upper Release Liner Shaft.
(Please reference 9. THREADING FILM for proper laminator webbing).
·
Please adjust the wheel to change the roller pressure with different material for the best laminating quality.
1. Lay the decaled image face down on a flat surface. Carefully peel back and put a crease along the edge of the release
liner.
2. With the image facing up, align the image onto the board. Press firmly from the center out.
3. Adjust the pressure lever to ensure the proper opening.
4. Flip the image over the upper roller and hold on to the release liner.
5. Press the foot pedal once, and then let it go while slowly pulling the release liner as the board enters the main roller nip.
6. Press the foot pedal once again when the board has completely exited from the rear of the unit.
7. Trim the board if necessary.
11. MAINTENANCE
Cleaning the Body of the laminator
1. To clean the machine body, dampen a cloth with water only and gently wipe the machine clean.
10. Adjusting the space of rollers
Warning: After reaching the bottom roller, please do not turn handle further
counterclockwise. Serious internal damage will result.
Turn the Nip Adjustment Wheel clockwise to raise the roller; turn the crank counterclockwise to lower the roller.
9.1.
Laminating
9.2.
Mounting