Royal Enfield Himalayan, Service Manual, Page: 163 / 214

ROYAL ENFIELD HIMALAYAN BS III VEHICLE SERVICE MANUAL
162
14.1 Dismantling from
vehicle
S.
No.
Fastener, Size, Tool Usage, Precautions, Photos
Aggregate to Dismantle /
Instructions

Ensure Ignition switch
and engine kill switch are
in OFF position.

Ensure fuel tap is in OFF
position.

Release the clips on the
fuel hose and
disconnect from
carburetor and fuel tap.

Release clip and
disconnect PAV inlet
tube from carburetor
end.

Disconnect TPS (black)
coupler from carburetor
LH side.

Loosen cable lock nuts &
push adjuster fully into
bracket.

Disconnect inner cable
from carburetor rotor.

Remove bottom nut
from adjuster and pull
up till it is free of the
bracket & slide inner
cable out of bracket.

Loosen screw on the
worm clip on inlet
manifold.

Loosen screw on worm
clip on the air filter
connection tube.

Gently slide carburetor
towards the rear such
that it comes out of the
inlet manifold.

Tilt carburetor towards
RH side and remove
from air filter connection
tube.
Double End Spanner:
10mm
Screw driver
CAUTION :
Ensure the worm clips are
loosened sufficiently before
removing carburetor.
NOTE:
Ensure the vent and drain
hoses are free from the frame
when removing carburetor.