Royal Enfield Classic 350, Owner'S Manual, Page: 35 / 100

3 4
ENGINE - OIL CHANGE
Secondary
Drain Plug
Primary
Drain Cap
(Refer Periodical Maintenance Chart for frequency)

Place motorcycle on its center stand on a firm flat
surface.

Start engine and warm up for 2 minutes.

Keep a clean tray below the engine

Remove primary drain cap, to drain oil & clean
suction filter, magnet.

Then remove secondary drain plug to drain oil &
clean the magnet.

Finally remove primary drain bolt to drain the
complete oil.
Primary
Drain Bolt

Remove the oil filter element on the Crankcase
Cover RH.

Allow the oil to drain by tilting the motorcycle to
both sides.

Wash the drain plug and the suction filter
thoroughly and refit on the crankcase after all the
oil is drained out.

Soak a new oil filter element in the oil and refit on
the Crankcase Cover RH.

Assembly 3 bolts and tighten them. Ensure ‘O’
Ring and gaskets are taken seat properly.
NOTE :
Replace oil filter element whenever oil is being
replaced.
CAUTION :
Filling up oil over “MAX” mark may cause smoke and
/ or loss of power. Do NOT allow oil level to fall below
“MIN” mark. Doing so may result in engine internal
damage or malfuncton.
 Fill recommended oil to
engine till the oil level is upto
“MAX” level mark in the oil
window in Crank-case Cover
RH.
Max
Min
Do it yourself