Document 80-0002, Rev. X6
11
4.2
F
OLDING AND
U
NFOLDING THE
W
HEELCHAIR
To unfold (see left picture): Place both hands on the seat upholstery
tubes and push them down. You should be careful and not put your
hand between the tubes and the wheelchair frame when unfolding. Be
sure that the seat is fully engaged with the wheelchair frame.
IMPORTANT! Risk of Damage
If seat is not fully engaged with the frame, damage to the chair frame
can occur.
To fold (see right picture): Remove the seat cushion if you have one.
Flip up the footrests. Lift the upholstery at the center of the seat and
pull the sides inward.
When packaged at ROWHEELS, the Revolution 1.0 has its fold-down
push handles in the “stowed” position. It is not recommended to use
the wheelchair in this configuration.
To engage the push handles, pivot each handle up until the latch pin
pops into place.
WARNING! Risk of Serious Injury or Damage
The latch pins MUST be engaged on both handles prior to use of the
wheelchair.
CAUTION! Risk of Moderate Injury
Take care to not get fingers pinched at the push handle pivot joint.
To stow the push handles, simple press the pin release lever just behind the
latch pin.
4.3
L
IFTING THE
C
HAIR
Lift the wheelchair using the push handles and the front upper
corners of the wheelchair frame, where the leg rests are attached.
