Rowe Scan 600-20, Operating Manual

Page: 56 / 140

57
5.11.3.3 Scan Format
In the field "Scan format", you can determine the
dimensions of the following scan. If you actuate the button
as shown in the adjoining figure, a menu pops up where you
can select the following settings:
Auto : The format is established automatically using the
width detection feature. In most cases, this setting induces
the requested result.
Figure 5.29: Scan format
Autoformat : The format is established automatically by
means of the width detection feature as in case of "Auto"
but afterwards it is extended to the standard format fitting
next. Moreover, the following options are available:
Orientation Portrait / Landscape: Select whether the
default format is portrait or landscape.
Fixed format On / Off : If the fixed format is
activated ( On ), the length in feeding direction is
considered in addition to the width when adjusting
to the default format. Otherwise, the width is
adapted to the default format, only.
If the fixed format is enabled, one part of the
information is cut off if the original is longer than
the fixed format to be adapted to by means of the
detected width.
Figure 5.30: Autoformat
Auto (sensor) : In order to enable gross detection of the
document width, the scanner is fitted with special sensors in
the feed path. In case of this setting, the detected document
width is used. Usually, a margin will then still be visible at
the sides which can be cut off manually afterwards. This
option is recommended for damaged originals if the
automatic width detection is not working properly.
Figure 5.31: Auto (Sensor)