58
5.10.3.3 Scan Format
In the field "Scan format", you can determine the dimensions of the
following scan. If you actuate the button as shown in the adjoining
figure, a menu pops up where you can select the following settings:
Auto
: The format is established automatically using the width
detection feature. In most cases, this setting induces the requested
result.
Figure 5.27: Scan format
Autoformat
: The format is established automatically by means of the
width detection feature as in case of "Auto" but afterwards it is
extended to the standard format fitting next. Moreover, the following
options are available:
Orientation Portrait/Landscape:
Select whether the default
format is portrait or landscape.
Fixed format On/Off
: If the fixed format is activated (
On
),
the length in feeding direction is considered in addition to
the width when adjusting to the default format. Otherwise,
the width is adapted to the default format, only.
The document has to be placed in the center.
If the fixed format is enabled, one part of the information
is cut off if the original is longer than the fixed format to
be adapted on the basis of the detected width.
Figure 5.28: Autoformat
Maximum width
: In case of this setting, the maximum document
width is used. Usually, a margin will then still be visible at the sides
which can be cut off manually afterwards. This option is
recommended for damaged originals if the automatic width
detection is not working properly.
Figure 5.29: Auto (Sensor)
