Roverpet 44PR Assembly Instructions Download

Page: 2 / 3

Roverpet

20 Kiji Dava Circle Prescott, Arizona 86301

800-658-5925

[email protected]

Page 2 of 3

3.) Insert one end of the

#48

CB’s into the large holes located near the ends of

(1)

#PR48LB. Slide the #48CB into the hole

until about 4” is protruding through.

4.) Install the second #PR48LB into the two remaining ends of the #48

CB’s, using the same method as before. Make

certain that all 4 legs installed in Step 2 are situated in the same direction.

5.) Take the assembled Roverpet Puppy Rail System and lower one side of the rails into your Roverpet whelping box. Line

up the #PR48LB connecting ends with the 2nd vertical bars of the whelping box panels.

Note:

Make sure the #PR48LB connecting end will not be installed on a door panel, rotate the Roverpet Puppy Rail Assembly

90* to avoid attachment on door panel. Verify the legs will rest on the floor of your whelping box when installation is complete.

6.) Clip the #PR48LB connecting ends around the vertical bars.

7.) With the one side of the #PR48LB installed on the vertical bars, slide the high-side of the Roverpet Puppy Rail System

down into the Roverpet whelping box. Make sure the #PR48LB connecting ends are installed in the same manner as in
the prior step.

Vertical Bars

Summary of Contents for 44PR

Page 1: ...ordered Assembly Procedure Special Notes If the Roverpet 4 x4 whelping box consists of a door panel it needs to be configured with the door located on the right to allow door hinge clearance Assembly...

Page 2: ...f the rails into your Roverpet whelping box Line up the PR48LB connecting ends with the 2nd vertical bars of the whelping box panels Note Make sure the PR48LB connecting end will not be installed on a...

Page 3: ...ystem down until all four legs are resting on the Roverpet whelping box floor Note Pig Rails can reduce the risk of possible suffocation Note Puppies should be watched at all times when small Congratu...