Rover 75 Saloon, Owner'S Handbook Manual

Page: 145 / 285

Harmony - Radio Tuning
145
3
Harmony - Radio Tuning RADIO TUNING
Manual tuning
If you know the frequency of the radio station you are seeking, or
you need to select a radio station that is too weak to be found by
automatic tuning, use manual tuning, as follows:
Select the desired waveband (FM or AM), then press the manual
tuning button (6) (‘MANUAL’ appears in the display). By pressing
either tuning button (5), the frequency changes (either up or
down) in steps of 0.1 MHz for FM, or 9 kHz for MW, or 1 kHz
for LW.
Fast manual tuning
By keeping either tuning button depressed, the waveband is
scanned rapidly up or down until the button is released.
Automatic tuning
Select the required waveband (FM or AM), then briefly press one
of the tuning buttons (5).
The radio automatically searches the frequency range (either up or
down depending upon which of the tuning buttons is pressed)
looking for a radio station of acceptable strength. Once a suitable
station is found, the search stops unless you choose to continue by
pressing the tuning button again.
NOTE: If you have a car telephone with a mute signal output connected
to the radio, the radio automatically mutes when the telephone is in use.
MONO/STEREO
Whenever the FM waveband is selected, the radio automatically
reproduces stereo sound, provided a suitable signal is available.
However, if a signal becomes too weak for good stereo reception,
only mono sound is produced until the signal strengthens
sufficiently for stereo sound reproduction.
ICE0142
5 6 5