Installation
Unpacking and Inspection
All Vicon equipment is tested and inspected before leaving the factory. It is the carrier’s responsibility to
deliver the equipment in the same condition as it left the factory.
Inspection for Visible Damage
Immediately inspect the cartons upon delivery. Make a note of any visible damage on all copies of the
carrier’s freight bill.
Make sure the carrier’s agent (the person making the delivery) signs the note on all copies of the bill. If the
agent does not have claim forms, contact the carrier’s office.
Inspection for Concealed Damage
As soon as possible after delivery, unpack the unit and inspect it for concealed damage. Do not discard the
carton or packing materials. If the unit is damaged, contact the carrier immediately and request forms for filing
a damage claim. Make arrangements for a representative of the carrier to inspect the damaged equipment.
If the equipment must be returned for repair, follow the Shipping Instructions at the end of this manual.
Roughneck V910 Dome Components
The Roughneck V910 units consist of a base (which includes the camera mounting bracket with the
camera/lens assembly) and a cover with a smoked dome. Refer to Figure 1.
Base/Camera Mounting Bracket
The base of the unit is constructed of die-cast aluminum. The base is mounted directly to the wall or ceiling.
Two cable access holes are provided. A safety cord is provided to connect the cover to the base. The camera
mounting bracket is attached to the base; the camera is factory-installed. The camera/lens position can be
manually adjusted. A heater is provided for units installed in environments that require it.
Cover/Dome
The cover of the unit is constructed of die-cast aluminum. It has a 4.7 in. (119 mm) diameter dome
constructed of smoked polycarbonate plastic. A mask with a slotted opening is included to help conceal the
camera. The cover is secured to the base with four tamperproof captive screws; a special tool is supplied to
loosen the screws. A safety cord is provided to anchor the cover/dome to the base. A heater is factory-
installed inside the base. Refer to the Maintenance section of this manual for instructions on the care and
handling of the dome.
2
•
5BInstallation
XX137-60-00 Rev 109 Roughneck V910 Dome Cameras with WDR
Summary of Contents for V910A-WDR
Page 2: ......
