JACKMAN FUSION EQUIP
–
ELECTROFUSION PROCESSOR OPERATORS MANUAL - REV 0
Page 6 of 48
INTRODUCTION
Preface
The information contained herein is the technical data and specifications for
JACKSON FUSION EQUIPMENT’s
Roughneck Electrofusion Processor
.
This publication was written to assist trained personnel in the proper procedures and operating functions of
the
Roughneck Electrofusion Processor
.
Operation of JACKSON FUSION EQUIPMENT should only be performed by trained and qualified personnel.
The technical data and advice contained herein are based upon tests and information believed to be reliable.
However, the operator should not rely upon it absolutely for specific applications. All data is given and
accepted at the user
’
s risk and confirmation of its validity and suitability in particular cases should be obtained
independently. JACKSON FUSION EQUIPMENT makes no guarantee of results and assumes no obligation or
liability in connection with its advice. The integrity of the piping system is the ultimate responsibility of the
installer. This publication is not to be taken as a license to operate under, or recommendation to infringe, any
patents.
Features
The
Roughneck Electrofusion Processor
is a reliable, easy-to-use, rugged tool designed to withstand
conditions found at typical construction sites throughout the world.
The
Roughneck Electrofusion Processor
is splash proof and highly shock resistant.
The
Roughneck Electrofusion Processor
can fuse all manufacturers’ fittings
requiring outputs that are within
the voltage and current values listed in the
Specifications Table
on page 7.
The
Roughneck Electrofusion Processor
operates most efficiently and reliably in the Barcode Fusion Mode;
however, it can be operated in Alternate Fusion Modes.
The Barcode Fusion Method is always preferred and
should be used whenever possible.
The
Roughneck Electrofusion Processor
has an intuitive user interface that is easy to learn.
The
Roughneck Electrofusion Processor
is equipped with internal memory for data storage and can be
downloaded to determine installation conditions and fusion cycle status.
The
Roughneck Electrofusion Processor
is capable of scanning and recording both ASTM F2897-11 and ISO
12176-4 Traceability barcodes.
The
Roughneck Electrofusion Processor
can be operated from any AC power source meeting the input power
requirements listed in the
Specifications Table
on page 7.
