JACKMAN FUSION EQUIP
–
ELECTROFUSION PROCESSOR OPERATORS MANUAL - REV 0
Page 32 of 48
Scanning Techniques
To scan a barcode, start by holding the
SMART Scanner™
about 6-8 inches from the barcode to be scanned.
Next, press and hold the
button
. A red aiming light will emanate from the end of the device as long as the
button
is held. Simply move the line over the barcode to be scanned. The
SMART Scanner™
will beep once
when the barcode is recognized. After the barcode is recognized, release the button. The following pictures
illustrate a few simple tips that will improve scanning reliability:
YES
For best results,
hold the SMART Scanner™
perpendicular to the barcode to be scanned.
YES
The aiming light should be centered and evenly
spaced over the barcode to be scanned.
NO
Do not hold the
SMART Scanner™
so that the
beveled scanning end is parallel to the barcode
to be scanned.
Although there are many cases where this
scanning technique will produce satisfactory
results, it does not work in all cases.
NO
Do not hold the aiming light at an angle to the
barcode.
NO
Make sure the aiming light completely covers the
barcode.
