Rottler P69AHD, Operation And Maintenance Manual

Page: 89 / 210

Section 5 Operating Instructions P69AHD Manual
www.rottlermfg.com
5-45
Inside Border
After the outside boarder/cross section has been define it is now time to define an inside boarder for the
probe to move to. This is a bit more of a manual process in the way points are collected. The first thing
to do is to highlight the cross section that we want to collect points for. In this case we want to highlight
“valve c/s” as shown below. What you will do here is to collect a series of point (8 to be exact) in the form
of a figure 8. You should have valves inserted at this point. Next, you will want to turn on the probe by
clicking on the “Setup” tab then table of tools. Inside of the table of tools there is a button labeled ‘Start
Probe’. Click on this button and you will see the probe become activated. Click back on to the “Digitize”
tab and we will begin collecting points for the figure 8.
With the probe on there are 8 points that you need to collect and manually record into the software. The
eight points are shown in the picture below.
To collect the points hand wheel the probe until the tip just makes contact with a point. You will see the
probe change from green to red once the tip makes contact. For each point you will click on ‘Tools’ then
‘Record Point’. (To make it easier you can just simply hold down the control key and press r to record the
point) When your are done you will have 8 points collected.