Rottler P69AHD, Operation And Maintenance Manual

Page: 63 / 210

Section 5 Operating Instructions P69AHD Manual
www.rottlermfg.com
5-19
PLANE #3
Manually rotate the A-axis such that the plane where the seat meets the head (see red arrow below in
point #2). You can rotate the A axis to the angle of the head for example the degree of the head and the
seat will be parallel to the table.
Start by clicking on “Add New Plane for Probing” button, then use the “Add A Plane Wizard” to set plane
#3. The three points to probe the plane will be as shown on the picture below, right after the valve seat
insert finishes (Where the red arrow is pointing at in the picture below)
We will be using the side of the probe, and there will be no need to move the plane perpendicular when
it’s been set. Try to line up the center of the probe right between the end of the seat insert and the port.
Set all three points as shown on the picture then click “OK” on the window to add the plane.
POINT #1 POINT #2 POINT #3