Rottler F103 Series, Installation Manual, Operation And Maintenance Manual

Page: 122 / 318

Section 5 Operating Instructions F103/4/5A Manual
www.rottlermfg.com
5-35
12” Multi Tooth Milling Head - 6865
This milling head holds 14 insert cartridges. Each insert has 10 cutting edges, 5 on each side. The inserts
need to be adjusted to be at equal height of each other to within .0004” (.01mm). To set the height of the
inserts, install the milling head into the machine spindle. Install the inserts. Back off the small set screw
above each tool cartridge. Loosen each tool cartridge, push up, and re-tighten.
Using an indicator with a large diameter convex tip, find the insert that is at the lowest setting. Now, adjust
the remaining inserts to equal height by turning the small set screw above each tool cartridge.
18” Multi Tooth Milling Head 6864
This milling head holds 9 insert cartridges. Each insert has 10 cutting edges, 5 on each side. The inserts
need to be adjusted to be at equal height of each other to within .0004” (.01mm). To set the height of the
inserts, install the milling head into the machine spindle. Install the inserts. Back off the small set screw
above each tool cartridge. Loosen each tool cartridge, push up, and re-tighten.
Using an indicator with a large diameter convex tip, find the insert that is at the lowest setting. Now, adjust
the remaining inserts to equal height by turning the small set screw above each tool cartridge. Install the
dampener band around the perimeter of the milling head.