Rothenberger ROCAM mini HD, Instructions For Use Manual

Page: 28 / 34

24 ENGLISH

Press the button (5), the LEDs indicate the charge level.
If one LED is flashing, the battery pack is almost flat and must be recharged.
Handling
Charging battery pack:

Push the battery pack completely to the stop on the sliding seat (2).
The operating indicator (3) flashes.
Conservation charge:
Once the charging process has finished, the battery charger automatically switches to conserva-
tion mode.
The battery pack can remain in the battery charger and is therefore always ready for use.
The operating display (3) lights up continuously.
Fault:
●
Warning display (4) lights up continuously.
Battery pack is not charged. Temperature too high/ too low. When the temperature of the battery
pack is between 0 °C and 50 °C / 32° - 122° F, the charging process begins automatically.
●
Warning display (4) flashes.
Battery pack is defective. Remove the battery pack immediately from the charger.
The battery pack was not pushed correctly onto the sliding seat (2).
5 Care and Maintenance
Always clean the device after every pipe inspection!

Turn the device off with the power button on the monitor and remove the battery, and pull
the electrical plug.

Close the cover and press until it clicks.

Take off the reel (6) from the ROCAM mini HD and clean under running water.

Only clean the reel when removed from device.
The device must be protected against water and must only be cleaned with a damp cloth!

Insert dried reel back into the device.
Charger:
Repairs to the charger must only be carried out by qualified electricians.
If the mains connection cable of this tool is damaged, in order to prevent endangering personnel
and property it must be replaced by the manufacturer, or the Customer Service of the manufac-
turer, or a similarly qualified person.
6 Accessories
You can find suitable accessories in the main catalog or at www.rothenberger.com