4
BA ROTEX HPSU compact 4 - 09/2013
1
x
Safety
1.4 Intended use
The ROTEX HPSU compact may only be used for preparation of
warm water, as a room heating system, and depending on its
design, as a room cooling system. Any other use outside the
intended use is considered as improper. The operator alone shall
bear responsibility for any resulting damage.
Proper use also includes observing the relevant maintenance
and servicing conditions. Spare parts must at least satisfy the
technical requirements defined by the manufacturer. This is the
case, for example, with original spare parts.
1.5 Instructions for operating safety
●
Work on the ROTEX HPSU compact (such as setup,
servicing, connection and initial start-up) is only to be carried
out by persons who are authorised and who have success-
fully completed qualifying technical or vocational training and
who have taken part in advanced training sessions recog-
nised by the appropriate responsible authorities. This, in
particular, includes heating specialists and climate control
technicians who have experience, as a result of their
technical training and their knowledge of the subject, of
proper and appropriate installation and maintenance of
heating, climate control and cooling installations and heat
pumps.
●
Electrical installation may be carried out only by electrical
engineers and in compliance with the valid electro-technical
guidelines as well as the regulations of the relevant energy
supply company (EVU).
For work on stationary refrigeration systems (heat
pumps) and air conditioning systems, proof of expertise
is required in the European Community according to
the F-Gases Directive (EC) No. 842/2006.
– Up to 3 kg coolant fill quantity:
Stationary equipment qualification category 2
– 3 kg coolant fill quantity or over:
Expert certificate category 1
Avoid damage caused by deposits and corrosion:
Observe
the relevant regulations of technology to prevent creation of
corrosion products and deposits.
Measures for desalination, softening or hardness stabilization are
necessary, if the filling and top-up water have a high total
hardness (> 3 mmol/l - sum of the calcium and magnesium
concentrations, calculated as calcium carbonate).
●
Using filling water and top-up water which does not meet the
stated quality requirements can cause a considerably
reduced service life of the equipment. The responsibility for
this is entirely that of the operator.
Summary of Contents for HPSU compact 304
Page 52: ...52 BA ROTEX HPSU compact 4 09 2013 10 x Notes 10 2 Other notes...
Page 53: ...10 x Notes BA ROTEX HPSU compact 4 09 2013 53...
Page 54: ...54 BA ROTEX HPSU compact 4 09 2013 10 x Notes...
Page 56: ...ROTEX BA ROTEX HPSU compact 4 Subject to change and correction 008 1414644_01 09 2013...
