78-00-00
page 18
July 01/2008
Effectivity 914 Series
Edition 1 / Rev. 2
d04356
BRP-Rotax
Maintenance Manual
Re-establish attachment (9) turbocharger bracket engine suspension frame (not
supplied with engine). Tightening torque as specified by the aircraft manufacturer.
Tightening torque of the M10 screws = 40 Nm (30 ft.lb).
Reconnect the two oil lines for turbocharger on the oil pump.
See 79-00-00.
◆
NOTE:
If the location of the oil line connection does not correspond with
oil pump housing, correction can be achieved by slightly turning
the turbocharger center section (34)
Fit the 4 exhaust bends (3).
◆
NOTE:
To make assembly easier, LOCTITE Anti-Seize can be applied
on the labyrinth end (36). See Fig. 78-11
The connecting ends (35) of the exhaust manifold must overlap the pleat of the
labyrinth end by at least 5 mm (.197 in.) at each of the 4 exhaust bends. See
Fig. 78-11
■
CAUTION: All 4 exhaust bends must be fitted free of stress and must not
be damaged during installation.
min. 5 mm
00163
Fig. 78-11
35
36
(min. 0.179 in.)
Summary of Contents for MMH-912 Series
Page 463: ......
