8
A
B
C
13. Installing Upper Enclosure Mounting Studs:
A) Install (6) M6 x 12 carriage bolts and mounting studs, Fig.
14. Mounting studs protrude outward from column.
14. Raising Carriages:
A)
Using appropriate equipment, raise carriage 43" (1100mm).
Be sure locking latch is securely engaged, Fig. 14.
15. Attaching Hydraulic Hoses:
A) Raise cylinders out of base plates, Fig. 15.
B) Attach hoses to cylinder, Fig 15 and Fig 15a.
C) After hoses are attached place cylinders back into base
plates.
D) Install hoses and hose clips, Fig. 15a.
E) Item G of Fig. 15a illustrates hose routing for EH1 and EH2
models. Hose will route through hole with grommet on the
inside of column and a hose clamp will hold it in place from
the
inside.
NOTE: Clean adapters and hoses. Inspect all threads for damage and
make sure all hose ends are crimped. Install hoses using Flared Fittings
Tightening Procedure, Section 16. Install hose clamps.
Fig. 14 Detail
A (5) M6 x 12. carriage bolt
B (5) Mounting studs
C Raise Carriages 43" (1100mm)
16. Flared Fittings Tightening Procedure:
Flared Fittings Tightening Procedure
1. Screw the fittings together finger tight. Then, using the proper size
wrench, rotate the fitting 2-1/2 hex flats.
IMPORTANT
Flare seat MUST NOT rotate when tightening. Only the
nut should turn.
2. Back the fitting off one full turn.
3. Again tighten the fittings finger tight; then using a wrench, rotate the
fitting 2-1/2 hex flats. This will complete the tightening procedure
and develop a pressure tight seal.
CAUTION
Overtightening will damage fitting resulting in fluid
leakage.
17. Oil Filling:
Remove fill-breather cap on power unit, Fig. 15a. Fill to
MIN____ mark on tank with Dexron III ATF, or hydraulic
fluid that meets ISO 32 specifications.
Replace fill-breather cap.
Fig. 14
Summary of Contents for SPOA3TE 600 Series
Page 22: ...22 NOTES...
Page 23: ...23 NOTES...
