Programming Cards and Tags
CP-R25 Hardware & Software Manual
Page 20
5.
Programming Cards and Tags
To configure the MIFARE cards and Tags the Configuration Tab
area of the Main Window is used.
There are two tabs used to configure different products
relating to MIFARE cards.
The following figure illustrates the different configuration areas
used when configuring the tab fields.
Figure 14: AS-B01 Sector Reader Configuration Tab Areas
There are three sub areas in the Configuration Tab area.
•
General Reader area – this area is the same for all
configuration functions
•
Reader Specific Configurations area – this area has two
different versions depending on whether it is a Sector
Reader configuration or a Swipe Reader configuration.
•
Operations area – this area varies according to the
configuration function being performed. The configuration
function is selected in the Operation Type drop down
menu.
When programming a MIFARE card or tag, the card or tag is
placed on the CP-R25 Desktop Programmer antenna area. The
following figure illustrates where these areas are located on the
CP-R25 Desktop Programmer.
