MD-08B
Programming Interface for Smartcard Readers
Installation and User Manual
1
1.
Introduction
The Rosslare's MD-08B MIFARE
®
Reader Programmer is used to set the
Wiegand output format of MIFARE read-only readers, while setting the
input control of the reader to either buzzer or LED control.
Figure 1: MD-08B
2.
Technical Specifications
Electrical Characteristics
Operating Voltage
12 VDC
Input Current
500 mA
Cable
RS-232 serial cable
Data Specifications
Reader
AY-M25, AY-W6350, AY-W6250, AY-K25,
AY-H25, AY-Q6250, and AY-Q6350
Software Requirements
Programmer Application
MIFARE Reader v0.05.00
3.
Connections
3.1
Connecting the MD-08B to the
Computer
Connect the MD-08B to a COM port in the computer using the RS-232
cable.
3.2
Connecting the Reader to the MD-08B
Connect the reader to the MD-08B according to the following wiring:
Red to +12V
Black to (-)
Green to D0
White to D1
If the reader comes with a Molex connector, connect it to JP4.
4.
Software Application
4.1
Starting the Software
1.
Connect the reader to the MD-08B.
2.
Run the MIFARE Reader Programmer application.
The
Mifare Reader Programmer window opens (Figure 2):
Figure 2: The Mifare Reader Programmer
3.
In Communication Settings, set
Com Port
to the port that the
MD-08B is connected to.
4.2
Setting Rosslare Mifare® Reader's
Transmission Format and LED Control
Input
1.
In Program options, set the parameters that you want to change in
the reader. For example, you can set
Transmit format
to
Wiegand 32-bit, and
LED control input
to Green LED.
2.
Disconnect the MD-08B from the power.
3.
Click the
Program
button to set the reader.
4.
Reconnect the MD-08B to the power by connecting the Power
plug.
If the programming was successful, the
Finish window opens
(Figure 3).
Figure 3: Finish Window
