Rosslare AYC-E/Q60 Series, Instruction Manual, Page: 66 / 73

Controller Functionality
66 AYC-E/Q60 Family Instruction Manual
5. The Mode LED flashes green.
6. Enter the assignment digit for the current user slot:
 “1” activates the Lock Strike relay only default
 “2” activates the Auxiliary relay only

“3”
activates the Lock Strike and Auxiliary relays
If the assignment digit is valid, three beeps are heard and the
controller returns to Normal mode.
If the assignment digit is invalid, a long beep sounds and the
controller waits for another assignment digit to be entered.
6.10.17 PIN Code Length/Factory Default Settings
You must be very careful before using this command!
Changing the PIN code length also erases the entire
memory contents, including all user and special codes, and
return all codes to their factory-default settings.
1. Enter Programming mode.
2. Select the desired PIN code length as follows:

00 – Returns to factory defaults and sets a 4-digit code.
 05 – Returns to factory defaults and sets a 5-digit code.
 06 – Returns to factory defaults and sets a 6-digit code.

08
– Returns to factory defaults and sets a 4-8 digit code
Note: When choosing the 4-8 option, please note that you
should either enter zeros before the code, or press
pound at the end (for example if your code is
12345 ,
enter either 00012345 or 12345# ).
Both the Mode and Door LEDs
flash red.
3. Enter your 4- to 8-digit
Programming code.
Mode/Transmit Door/Program
Green Orange
Mode/Transmit
Door/Program
Red Red
Mode/Transmit Door/Program
Green