Ross Ultrix 2101DR-008-11, Manual, Page: 13 / 56

Ultrix SFP Modules Guide (v11.0) Getting Started • 13
Getting Started
This section provides a general overview of how to install an SFP module into an AUX port on the rear panel of the
Ultrix router. Refer to the documentation that accompanied your SFP module for installation details.
 Ross Video Ultrix routers support only Ross Video branded SFP modules. SFP modules from other vendors may
yield unpredictable results.
Before You Begin
Throughout this manual, please heed the following cautionary note:

The following modules are no longer available from Ross Video: SFP-ANA-IO, SFP-HDB-IN-12G, and
SFP-HDB-OUT-12G.
Installation Overview
This section provides a general overview of how to install an SFP module into an AUX port on the rear panel of the
Ultrix router.
For More Information on...
• installing an SFP module, refer to the documentation that accompanied your SFP module.
To install an SFP module in an AUX port
1. Remove the dust cap from the AUX port on the Ultrix rear panel as follows:
a. Locate the AUX port you wish to install the SFP module into.
b. Grasp the cap between your thumb and forefinger and gently press on the sides.
c. Pull the cap towards you and away from the port.
d. Store the dust cap for later use.
2. Locate the markings on the SFP Module chassis that identify the orientation for installing. These markings may
include Tx/Rx icons, or arrows that indicate the direction.
3. Align the SFP Module in front of the empty AUX port.
4. Insert the SFP Module into the AUX port, ensuring it is seated home and the latch is engaged.
ESD Susceptibility
— Static discharge can cause serious damage to sensitive semiconductor
devices. Avoid handling circuit boards in high static environments such as carpeted areas and when
synthetic fiber clothing is worn. Always exercise proper grounding precautions when working on circuit
boards and related equipment.
Caution
— Do not remove the dust caps from the AUX port until you are ready to install the SFP
Module.
Caution
— Do not install the SFP-FIBER-3G or SFP-MADI-FIBER modules with fiber-optic cables
attached. Doing so can damage the cables, the cable connector, the SFP Module or all three.
Caution
— Do not remove the dust caps from the SFP Module until you are ready to connect the
cables.