Ross Ultricore RCP-ME, User Manual, Page: 27 / 98

RCP-ME User Guide (v4.0) Getting Started • 27
To-deassign a resource
1. Select the destination to which the resource is attached.
2. Press DE-ASIGN .
If the selected destination does not include a resource, one of two things will occur:
• If the panel is in MC mode, park the current destination (switch same source number to destination).
• If the panel is not in MC mode, it displays the
MC MODE? message.

The ability of a panel to de-assign a resource using the de-assign button will depend on the priority assigned to
the panel and the resource in the NK-VRC virtual routing core.
Resetting Devices
To return the RCP-ME to a known operating state and configuration, perform one of the following:
• send a saved configuration to the RCP-ME (see “ Saving the Current Configuration for the RCP-ME ” on
page 73)
• reset the RCP-ME
• reload the factory defaults on the RCP-ME
If the RCP-ME fails to accept any configuration files that are sent to it, then you should reset the device. When you
perform a reset, the RCP-ME takes on the last-known operating state and configuration that is stored in memory. If
the RCP-ME fails to reset, then reload the factory defaults.
To reset a device
1. Open the RCP-ME Panel Config interface (see “ To open the RCP-ME Panel Config interface ” on page 22).
2. Click
Reboot
.
To reload a default configuration
1. Open the RCP-ME Panel Config interface (see “ To open the RCP-ME Panel Config interface ” on page 22).
2. Select the Configuration tab.
3. Select the Load factory defaults check box.
4. Click
Send Configuration
.
The panel will reload factory defaults.

If the RCP-ME is connected to an Ultricore control system, the default labels will be overwritten with the current
database. The button assignment will remain as per the default.