Ross Synergy MD, Engineering Manual, Page: 284 / 388

10–38 • Custom Controls Synergy Q/MD Engineering Manual (v9.1 MD)
Naming Custom Controls
A custom control button can be named for ready identification in the menus, and in the mnemonic
displays if that option is installed.
Once your custom control buttons have been programmed, be sure to properly name and label them.
Refer to the section “ Control Panel Pushbutton Inserts ” on page 4-25 for instructions on labeling
the actual buttons.
Use the following procedure to apply a name to a custom control button.
1. Navigate to the Custom Controls Menu 1-2 as follows:
• Press HOME B Custom Controls .
2. Select the custom control button you want to set the name for:
• Use the Bank knob to select the custom control bank with the custom control you
want to set the name for.
• Use the Button knob to select the custom control button that you want to set the
name for. You can also press the desired button directly on the control panel.
Remember that buttons marked with an asterisk (*) in the list have already been
programmed.
3. Press Modify Name to display the Custom Control Name Menu 1-2 .
Custom Control Name Menu 1-2, with Optional Mnemonic Field
4. Assign a New Name to the custom control as follows, or continue to the next step to
enter a Preset Name :
• Use the Horizontal knob to move the cursor horizontally up or down a row to
select a letter.
• Use the Vertical knob to move the cursor vertically up or down a column to select
a letter.
Note
The Synergy 1 control panel does not support the Mnemonics Display
option and does not show the Mnemonic preview in the Custom
Control Name Menu .
Operating
Tip
A Standard PS/2 keyboard can be used to perform the same actions as
pressing or rotating the
System Control
buttons and knobs.
Note
As you rotate the Horizontal and Vertical knobs, note that the MLE
pushbuttons that correspond to each character (in sequence) light. If
desired, you can press the MLE pushbutton to select a character.