Ross Synergy MD, Engineering Manual, Page: 246 / 388

9–20 • Basic Communications Setup Synergy Q/MD Engineering Manual (v9.1 MD)
• Press
Cancel
to exit the menus safely, without making any changes. The system
returns to the previously stored settings.
This completes the procedure for setting up the switcher communications port for a UMD Input
device.
UMD Input Device BNC Setup
In order for the Synergy Q/MD switcher to associate a mnemonic name with an input, each Input
BNC must be associated with a UMD address. As the source routed to the switcher changes, the
mnemonic name for that Input BNC also changes.
Use the following procedure to assign a particular UMD Input address to an Input BNC:
1. Navigate to the BNC Menu 3-3 as follows:
• Press
HOME B More B Setup B Installation B BNC B More B More
.
2. Press
UMD Inputs
on the BNC Menu 3-3 .
UMD Input — BNC Menu 3-3
3. Assign a BNC to a UMD address as follows:
• Use the
BNC
knob on the BNC Menu 3-3 to select the Input BNC that you want to
set the UMD address for.
• Use the
UMD #
knob on the BNC Menu 3-3 to select the UMD Input address that
you want to assign to the selected Input BNC. Select
Off
to not assign a UMD
address to the selected Input BNC.
4. Press
HOME
to display the Installation Change Confirmation Screen .
5. Accept or reject the changes you have made as follows:
• Press
Confirm
to accept the changes.
• Press
Cancel
to exit the menus safely, without making any changes. The switcher
returns to the previously stored settings.
This completes the procedure for assigning a particular UMD Input address to an Input BNC.