Ross SYNERGY 4000DR-003, Operation Manual, Page: 296 / 332

9–16 • Custom Controls Synergy Series Operation Guide (v18)
control panel. Remember that buttons marked with an asterisk (*) in the list have
already been programmed.
3. Navigate to the Insert Router Control Menu as follows:
• Press
Start Recording B Insert Special B Special
.
Insert Special — Special Menu
4. Assign a pause to the custom control as follows:
• Use the top knob to select
Pause CC
.
• Use the
Seconds
knob to set the duration of the pause in seconds.
• Use the Frames knob to set the duration of the pause in frames.
Main Menu — Custom Control Held
5. Press
Insert
to enter the Custom Control Hold into your custom control macro.
6. Press
UP ONE
to return to the Custom Controls Recording Menu .
7. Press
Finish Recording
, or the flashing custom control button, to finish recording to
the selected custom control. The custom control button will stop flashing.
Once your custom control buttons have been programmed, be sure to properly name them. Refer to
the section “
Naming Custom Controls ” in the Synergy Series Installation Guide , for more
information on naming custom control buttons.
To play back your macro, exit the Custom Controls Menu and press the custom control button on the
control panel that you recorded the custom control macro to. Any recorded custom control can be
edited. Refer to the section “
Editing Custom Control Macros ” on page 9–20 for details.
Operating
Tip
As a recommendation, keep special functions grouped together on
your
physical custom control buttons.
Note Similar to a Custom Control Hold, a Pause will display a message on
the
Main Menu or the Custom Control Menu indicating that the
custom control is paused.