Ross SYNERGY 4000DR-003, Operation Manual, Page: 257 / 332

Synergy Series Operation Guide (v18) Memory Functions and More • 8–15
Once you select the bank, the number is displayed on the display (in the 10’s digit
column).
• Select the register within the bank (the 1’s digit), by pressing the number (from
0
to
9
). The number is displayed on the display and the effect is immediately recalled.
You do not need to press
ENTER
.
Refer to the “ Recall Register Notes ” section for important information regarding the recall procedure
itself, and the use of
UNDO
.
Recall Register Notes
Please note the following important points regarding memory register recall:
• If you accidentally recalled the wrong register, press
UNDO
to restore the MLE (or
group of MLEs) to its state immediately before the recall. The
UNDO
button turns on
immediately after the recall has been performed, giving you one chance to undo the
operation.
~ You can press
UNDO
provided that you do not touch any other switcher button or
move any Fader . (Turning knobs are allowed.)
~ If another button is pressed or if a Fader is moved, the
UNDO
light turns off and
the recall cannot be undone .
• Recalling a register changes the displays in both the Global Memory System group
itself, and in any individual MLE’s Memory Group display that is affected by the
recall.
• When a register is recalled that includes an off-limit Fader , the system brings the effect
back as a temporary “ Transition Limit .” You can use the
AUTO TRANS
button in the
normal way to complete the transition, or return the transition to its starting point.
Please note:
~ Any actual Transition Limit functions are recalled as originally programmed,
whether or not the TRANS LIMIT button is lit.
~ Similar to the actual Transition Limit function, with the temporary function note
that “physical” and “electrical” Fader positions may not match when a register is
recalled.
• If you recall a register and the display indicates Memory # BAD , and simultaneously,
all buttons in the affected keypads blink, it indicates that the memory location is
corrupted. Press
any button on the blinking keypad to clear the message and stop the
blinking. The switcher will not act on this button press.
• It is possible to recall a memory while retaining a current video crosspoint. This can be
accomplished in one of the following ways:
~ By holding down the crosspoint of the video that you want to keep, and then
recalling the desired memory. This feature applies to both key buses, as well as the
background and preset buses.
~ By enabling the Bus Hold function in the panel mapping, and pressing the BUS
HOLD crosspoint button. This feature is available to multiple buses at a time. Refer
to the section “ Bus Hold Mode ” on page 4–24 for details on performing a Bus
Note If the desired bank is already selected, you need only select the register
(from 0 to 9 ) to immediately recall the setup.