Ross SYNERGY 4000DR-003, Operation Manual, Page: 152 / 332

6–2 • Pattern Control Synergy Series Operation Guide (v18)
Pattern Control Group
Each switcher includes one Pattern Control group, which is located in each panel’s top right-hand
area. Every MLE (including the Program/Preset MLE) has two pattern generators:
• Pattern generator 1 is shared between the MLE’s Wipe Generator and the Preset
Pattern Generator in the MLE’s Keyer 1 (or DSK 1 ). This pattern generator is
full-featured — all wipe patterns are available.
• Pattern generator 2 is used exclusively by the Preset Pattern Generator in the MLE’s
Keyer 2 (or DSK 2 ). This generator is restricted to the first six columns of patterns (as
shown in the Pattern Selection Section ), minus the circle. Matrix wipes are not
available.
Each Pattern Control group is slightly different in its layout.
• Synergy 2 — The following figure illustrates the Pattern Control group for the
Synergy 2 panel:
Note
Because pattern generator 1 is shared, if
PST PATT
is enabled in
Keyer 1 , you cannot press the
WIPE
button in the MLE’s Transition
group. Similarly, if
WIPE
is enabled and you select a
PST PATT
key
type in Keyer 1 , the
WIPE
button turns off and the transition type
reverts to
DISS
.
1) Pattern Assignment Section
2) Pattern Selection Section 3) Pattern Direction Section
4) Pattern Adjustment Section
2
PATTERN CONTROL
ROT ASPECT
MLE
1
MLE
2
WIPE
PP1
DVE
NORM
REV HMULT
VMULT
FLIP
FLOP
S&T
WIPES
PST
PATT2
ASPECT BORDER SOFT ROTATION
USER
1
USER
2
USER
3
SET
USER
USER
4
USER
5
USER
6
USER
7
1 2 3 4 5 6 7 8 9 0
30
20
10
0
4
3
1