Ross SYNERGY 4000DR-003, Operation Manual, Page: 143 / 332

Synergy Series Operation Guide (v18) Background Transitions • 5–11
7. If the background image is wrong, select the correct image on the PST bus — or
alternately, change the state of the
BKGD
button.
8. Once you have confirmed that the next image is correct on Preview , perform the
transition — either manually with the Fader , or automatically using
CUT
or
AUTO
TRANS
. Remember that the “next transition” buttons stay lit after the transition is
complete.
Auto Transitions
The AUTO TRANS button is used to start an automatic (smooth) transition between the selected PST
and PGM bus sources.
Note the following important rules:
• An auto transition, once in progress, cannot be paused.
• To “escape” from an auto transition in progress, you can either press CUT during the
transition, or manually pull the Fader in the proper direction. The “cut” action instantly
completes the transition.
• You cannot initiate an auto transition or a cut if the Fader is off its upper or lower limit.
Changing Program/Preset Auto Transition Rates
Use the following procedure to change the auto transition rates in the Program/Preset Transition
group:
Program/Preset Transition Group — Fader
1. Verify the current transition rate displayed in the Program/Preset Transition Group.
2. In the Global Memory System group, press the RATE button for the highest-numbered
MLE:
• Synergy 2: MLE 2 RATE
• Synergy 3: MLE 3 RATE
• Synergy 4: MLE 4 RATE
FRAMES