Ross Synergy 2 SD, Installation Manual

Page: 95 / 414

Synergy Series Installation Guide (v18) Preliminary Cabling and Check • 3–7
Animated Logo Generator (CDK-111A-M) Cabling
This section explains how to connect the Animated Logo Generator (ALG) to your Synergy 2, 3 or 4
SD Switcher.
Use the following procedure to connect the ALG to your Synergy SD Series switcher:
1. Using industry standard coaxial cable and BNC connectors, connect a digital reference
signal from your facility’s house sync generator to the IN BNC of the CDK-111A-M.
2. With the CDK-111A-M in ALG mode, BNC 5 and BNC 6 are the Fill and Alpha
outputs, respectively, for the logo(s) stored on the card. Using industry standard coaxial
cable and BNC connectors, connect these
Fill and Alpha outputs to any Synergy
switcher inputs as designated by the facility engineer.
3. For remote control of the CDK-111A-M in ALG mode, connect the DCP-111 panel to
BNC 2.
ALG (CDK-111A-M) Cabling Diagram
Important Before turning on the power, please ensure that the rotary switch on the
front edge of the CDK-111A-M card, as indicated on the following
diagram on page 3–8 is turned to position 0. This is the normal
operating position for your CDK-111A-M when in ALG mode.
Refer to Chapter 8, “ Animated Logo Generator Mode ”, in the
CDK-111A-M Owner’s Guide for information on controlling the ALG
using either the card edge buttons or the DCP-111 remote control
buttons.
House Sync Generator ALG (CDK-111A-M) Synergy Switcher
BKGD1 In IN
BKGD2 In 1
Panel 2
Not Used
3
Not Used
4
Logo Fill Out
5
Logo Alpha Out 6
7 External Key Fill In
8 External Key Alpha In
Digital Reference
Signal Out
Designated Switcher Input 1
Designated Switcher Input 2
DCP-111 Remote Control
(Optional)
A B
E R R
FAST S LOW
A DJ
O N O N O N O N
K EY 1 K EY 2
T
RA N S
R
A T E
M
EN
U
-
I TE
M
-
S
EL
EC
T
B
K G D
E
X TE R N A L
I
NT E R N A L
AUTO
CUT
AUTO
CUT
AUTO
CUT
FADE
TO
BLACK
MENU
D IG ITA L
MIX E R
K E Y E R
M
EN
U
+
I TE
M
+
CDK