Ross Synergy 2 SD, Installation Manual

Page: 63 / 414

Synergy Series Installation Guide (v18) Installation • 2–19
2. In addition to the cut-out measurement, ensure that there is sufficient clearance under
the desktop for connectors and cables on the rear of the control panel. Approximately
four inches (10.1 cm) of clearance should be sufficient for each switcher, as shown in the
following diagram.
Detail — Control Panel Connector Clearance Requirements
3. Install the control panel in your console. Each tub drops into the cut-out from above and
rests on edge supports at the sides.
4. Remove the two tie-down bolts that are located on the underside of the tub. The control
panel tub will not open until these bolts are removed. Once the bolts are removed, it is
recommended that you re-install them
from the top — making sure that they do not
protrude through the bottom of the tub.
5. Normally, fasteners are not required to hold the control panel in place. However, if your
installation requires it (particularly for remote trucks), you can attach the tub to the desk
using the pre-drilled mounting slots on each side of the tub. Wood screws are not
supplied.
Detail — Optional Mounting Screw Attachment
Note Once the panel is fully installed, you may also consider re-installing
the bolts
from the bottom — to prevent unauthorized access to the
inside of the tub. If you elect to do this, ensure that the power switch
(inside the tub) is in the
ON position.
Desktop
Level
Depth Below Desktop
(All Switchers)
2.5" (6.4 cm)
Minimum Cable Clearance
(All Switchers)
4.0" (10.1 cm)
Mounting Slots for
#4 or M3 Screws
(3 Slots, Both Sides)
Desktop
Level
Control Panel Tub
Control Panel
(Rear View)
Optional Mounting Screws
(Both Sides) #4 or M3 Screws