![Ross Synergy 2 SD Installation Manual Download Page 56](http://html1.mh-extra.com/html/ross/synergy-2-sd/synergy-2-sd_installation-manual_1489028056.webp)
2–12 • Installation
Synergy Series Installation Guide (v18)
Connector layout is identical for all Synergy switchers.
1. Power Connectors
Two AC connectors are provided for chassis power.
•
Connect primary power to the connector labeled
PRIMARY
.
•
If installed, connect backup power to the connector labeled
REDUNDANT
. Note
that this connector is always installed, whether or not you have the
Redundant
Power Supply
option mounted inside the chassis.
2. Input Section
Sixty-four BNC connectors are provided for up to 64 digital video inputs. Each input is
identified in the label array to the right of the connectors. The following sets of inputs
are standard, but each switcher can be expanded to the maximum 64 inputs (in groups of
8 inputs each).
•
Synergy 2
: 16 serial digital inputs
•
Synergy 3
: 24 serial digital inputs
•
Synergy 4
: 32 serial digital inputs
Even though an input is
physically
connected to a numbered input connector, you can
electronically place that input anywhere on the control panel’s MLE bus row. All input
configuration is performed through the menu system.
3. Main Output Section
Ten BNCs are provided for the switcher’s main outputs including the
CLEAN
feed
output. Please note:
•
One program (
PGM
) and one preview (
PV
) output are provided for each MLE. The
left-most program output provides a
second output
for the highest-numbered MLE
in your system:
~
Synergy 2
: provides a second MLE 2 output
~
Synergy 3
: provides a second MLE 3 output
~
Synergy 4
: provides a second MLE 4 output
•
Each output is identified in the label array to the
left
of the connectors.
The following table summarizes the active program and preview outputs on each
Synergy switcher.
If DAs are required to provide additional outputs for a particular signal, contact Ross
Video or your Ross dealer for details.
Active Program and Preview Outputs
Output
Switcher
MLE 1
PGM / PV
MLE 2
PGM / PV
MLE 3
PGM / PV
MLE 4
PGM / PV
Main
PGM
CLEAN
Synergy 2
Active
Active
Active, MLE 2 Active
Synergy 3
Active
Active
Active
Active, MLE 3 Active
Synergy 4
Active
Active
Active
Active
Active, MLE 4 Active
Summary of Contents for Synergy 2 SD
