Ross Synergy 2 SD, Installation Manual

Page: 373 / 414

Synergy Series Installation Guide (v18) External DVEs • 13–27
In addition, once communication is properly set up with the Dveous, the “ DVE Send ” feature is
operational. This feature allows you to perform fast and simple DVE transitions from the switcher
panel — as easy as selecting a Dissolve or a Wipe. When you set up a
DVE Send transition, you are
electronically routing a specific set of signals from the selected MLE to the Dveous for processing —
and then
back into the MLE for keying.
In the Synergy Series Operation Guide , refer to Chapter 11 “ DVE Send ” for complete instructions on
the DVE Send feature.
Dveous Serial Connection
This section describes the requirements for interfacing the Synergy switcher to the Accom Dveous.
Use the following procedure to connect the Synergy switcher to the Accom Dveous DVE:
1. On the rear of the Dveous frame, locate the connector marked
Editor
, on the Dveous
frame communications board as shown below:
Dveous Frame — Editor Connector
2. On the Synergy frame, locate the connector marked DVE 2 .
3. Construct a custom cable using the table “ Synergy Frame to Dveous Wiring Chart ” as
a guide. The cable must use standard male 9-pin “D” subminiature connectors at both
ends.
Note
Connector
DVE1
may also be used if the Synergy switcher is set to use
that connector as the primary DVE.
Synergy Frame to Dveous Wiring Chart
Synergy Control Panel Accom Dveous
Synergy
DVE 2
Signal Dveous Editor A53D
mode
Signal
1 Frame GND
→
1 Chassis GND
2 Transmit A (-)
→
8 Receive A
3 Receive B (+)
→
3 Transmit B
4 Receive
Common
→
6 Signal Ground
5 n/c n/c n/c
6 Transmit
Common
→
4 Signal Ground
7 Transmit B (+)
→
2 Receive B
8 Receive A (-)
→
7 Transmit A
9 Frame GND n/c Signal Ground
pin 9
AUX LINC LINC
OFF ON
EDITOR C/P GPI IN GPI OUT