Ross Synergy 2 SD, Installation Manual

Page: 311 / 414

Synergy Series Installation Guide (v18) Completing Setup • 10–19
• Switcher Registers
This set of registers stores default settings for the control panel, similar to those
discussed in the section “
Resetting the System ” on page 3–12. When reset, the control
panel (and all associated crosspoints, keyers, and MLE settings) is essentially cleared to
zero.
• Installation Registers
This set of registers stores default settings for all switcher setup and software-based
configurations. When reset, the following areas will return to factory default values:
• Custom Control Registers
This set of registers stores the functions that you have programmed into the switcher’s
Custom Control Group . These functions can include VTR remote control commands,
DVE control commands and other panel-specific macros (programmable keys). When
reset, all registers are cleared (empty).
• Default NV-RAM
When reset, the switcher’s non-volatile RAM is cleared.
• Default S&T3D
When reset, all of the 3D cards present in the switcher are defaulted to factory settings.
• VTR Clip Registers
When reset, all VTR Clip registers are essentially cleared out (or erased).
• BNC Input Names • Aux Bus Setup
• BNC Input Types • Output Setup
• Tally Configuration • Clean Feed Setup
• Alpha Setup • GPI Input / Output Setup
• Auto Key Configuration • Device Setup
• Panel Button Assignments • Editor Communications Setup
• Option Card Setups • Custom Banks
• Calibration • Custom Device Setup
• Reference Delay