Ross Synergy 2 SD, Installation Manual

Page: 300 / 414

10–8 • Completing Setup Synergy Series Installation Guide (v18)
Disk Store Menu 1-2
If a File Icon appears above a softkey label (such as Custom Controls ), the storage
device contains a file of that type.
4. Press
MORE
to display the Disk Store Menu 2-2 .
5. If you wish to save all categories of registers to a storage device, press
All
. This action
writes the following seven files to your storage device in succession:
• Memory Registers are stored in the file MEMORYS.SYN .
• S&T3D Memories (if the Squeeze & Tease WARP option is installed) are stored
in the file ST3DMEM.SYN .
• Custom Control Registers are stored in the file CUSTCTRL.SYN .
• Personality Registers are stored in the file PERS.SYN .
• VTR Clip Registers are stored in the file VTR.SYN .
• Installation Registers are stored in the file INSTALL.SYN .
• 3D Sequence Registers are stored in the file ST3DSEQ.SYN .
6. If you wish to save only the three files that pertain to your installation setups, proceed as
follows:
• Press Custom Controls to save Custom Control Registers to a storage device.
The file CUSTCTRL.SYN is written to the storage device.
• Press Personality to save Personality Registers to a storage device. The file
PERS.SYN is written to the storage device.
Important Pressing All Pre-V12 Format stores all of the above registers to your
storage device in a format that is compatible with switcher software
versions earlier than version 12. Therefore, if you are downgrading
your switcher software from version 12 to an earlier version, use this
method to store all your switcher configurations to a floppy disk. If
you are using a USB key, you can transfer the files to a floppy disk
using your PC.
Note that a floppy disk created in this manner can still be loaded into
version 12 or newer software, but it will load significantly slower than
a disk that was saved using the
All
softkey.
Note
If you wish to have all registers stored to a storage device, but would
like to store the memories individually, you must store
each category
individually . Pressing
All
will not store memories in individual files.