Ross Synergy 2 SD, Installation Manual

Page: 274 / 414

9–44 • Additional Installation Setups Synergy Series Installation Guide (v18)
• Calibrate the Y-Axis by moving the joystick fully up and down. Repeat this
procedure two or three times.
• Calibrate the Z-Axis by twisting the joystick knob fully clockwise, then
counterclockwise. Repeat this procedure two or three times.
As you move the joystick, you will see a series of numbers appear in the Main Area ,
under the
POSITIONER
heading. The numbers for each axis may not match — this is
normal.
4. To calibrate the knobs:
• Move each knob fully left and right.
• Repeat this procedure two or three times for each knob .
As you move the knobs, you will see a series of numbers appear in the Main Area ,
under the
KNOBS
heading. The numbers for each knob may not match — this is
normal.
5. Ensure that the label
Not Moved
does not appear in the Main Area . This guarantees
that you moved each control.
6. At this point, you can complete the calibration or exit the menu safely:
• To exit the menu safely, without accepting the newly calibrated controls, press
HOME
.
• To complete the calibration, press
Accept
.
This completes the procedure to calibrate the switcher’s analog controls.
Caution When you press Accept , do not hold the positioner off center. This
will program a false “center” for the joystick, and you will have to
re-calibrate the switcher again to clear it.