Ross Synergy 2 SD, Installation Manual

Page: 215 / 414

Synergy Series Installation Guide (v18) Custom Control Basics • 8–39
Copy MLE Custom Controls
The Copy MLE function allows you to copy the contents, including crosspoints, matte generator
values, fader positions, on-air status, key active status, and key over priorities, of an MLE to another
MLE location on the switcher. You can record a Copy MLE function to a custom control button using
the Custom Controls Menu.
Use the following procedure to create a custom control macro that copies the contents of one MLE to
another MLE location:
1. Navigate to the Custom Controls Menu as follows:
• Press HOME B Custom Controls .
Custom Controls Menu
2. Select the Custom Control bank and button that you want to record to as follows:
• Use the Bank knob to select the custom control bank that you want to record the
custom control on.
• Use the Button knob to select the custom control button that you wish to program.
You can also press the button directly on the panel.
3. Press Start Recording to display the Recording Menu .
4. Insert a Copy MLE function as follows:
Note
Buttons with an asterisk (
*
or
@
) next to them in the list are already
programmed, however, they can be edited.
Note
Press Cancel Recording to terminate the programming procedure.
The macro will not be recorded.
Operation
Tip
All copy functions use the “ Destination - Source ” method, in which
the desired destination button is pressed first, followed by the source
button (the location from which you want to copy). Because the
switcher senses the “held” button (
Destination ), the source button can
be pressed without affecting the on-air status of the switcher. Refer to
Chapter 4, “
Switcher Basics ” in the Synergy Series Operation Guide
for more information on Copy and Swap functions.