Ross Synergy 2 SD, Installation Manual

Page: 211 / 414

Synergy Series Installation Guide (v18) Custom Control Basics • 8–35
Custom Controls Menu — Custom Control Held Pop-up
5. Press
Insert
to enter the Custom Control Hold into your custom control macro.
6. Press
UP ONE
to return to the Custom Controls Recording Menu .
7. Press
Finish Recording
, or the flashing custom control button, to finish recording to
the selected custom control. The custom control button will stop flashing.
This concludes the procedure to place a
Hold CC
within a custom control sequence.
Once your custom control buttons have been programmed, be sure to properly name them. Refer to
the section “
Naming Custom Controls ” on page 8–42 for more information on naming custom
control buttons.
To play back your macro, exit the Custom Controls Menu and press the custom control button on the
control panel that you recorded the custom control macro to. Any recorded custom control can be
edited. Refer to the section “
Editing Custom Control Macros ” on page 8–47 for details.
Custom Control Pauses
Use the Custom Control Pauses feature to place “pauses” within a custom control sequence. With a
pause inserted, a sequence can have a duration rather than being executed instantaneously. With
multiple pauses placed in between macro events, controlled switching between sources becomes
possible. Pressing the custom control button again during the wait time will immediately resume the
macro.
Use the following procedure to place a pause within a custom control macro:
1. Navigate to the Custom Controls Menu as follows:
• Press HOME
B
Custom Controls .
Custom Controls Menu
2. Select the custom control button you want to record to as follows:
• Use the
Bank
knob to select the custom control bank you want to record the custom
control to.
• Use the
Button
knob to select the custom control button that you want to record a
custom control macro to. You can also press the desired button directly on the