Ross Synergy 2 SD, Installation Manual

Page: 208 / 414

8–32 • Custom Control Basics Synergy Series Installation Guide (v18)
Custom Controls Menu
2. Select the custom control button you want to record to as follows:
• Use the
Bank
knob to select the custom control bank you want to record the custom
control to.
• Use the Button knob to select the custom control button that you want to record a
custom control macro to. You can also press the desired button directly on the
control panel. Remember that buttons marked with an asterisk (*) in the list have
already been programmed.
3. Navigate to the Special Menu as follows:
• Press
Start Recording B Insert Special B Special
.
Insert Special — Special Menu
4. Change the Roll VTR Mode as follows:
• Use the top knob to select
Roll VTR Mode
.
• Use the Roll VTR Mode to select a Roll VTR Mode . You can select between the
following:
~
Play
— Select this option to issue a Play command to the serial device when
the
Roll VTR
button is selected in the PST Bus. This is the default setting.
~
Arm
— Select this option to enable the Synergy switcher to automatically
transition the device to air after the preroll interval has lapsed.
Operating
Tip
As a recommendation, keep special functions grouped together on
your
physical custom control buttons.
Note If an Auto Transition is performed with the ROLL VTR active, and in
Arm or Armed Always Mode , the switcher will apply the Pre-Roll
time for the device before it takes the device on-air.