Ross Synergy 2 SD, Installation Manual

Page: 189 / 414

Synergy Series Installation Guide (v18) Custom Control Basics • 8–13
Programming Control Panel Functions
Use the following procedure to program a normal custom control button with basic functions:
1. Navigate to the Custom Controls Menu as follows:
• Press HOME B Custom Controls .
Custom Controls Menu
2. Select the Custom Control bank and button that you want to record to as follows:
• Use the Bank knob to select the custom control bank that you want to record the
custom control on.
• Use the Button knob to select the custom control button that you wish to program.
You can also press the button directly on the panel.
3. Press Start Recording to display the Recording Menu .
Custom Controls — Recording Menu
Operating
Tip
If you are programming long or looping custom controls, you should
keep at least one unprogrammed custom control. Pressing an
unprogrammed custom control button, one with no macros recorded on
it, will stop a running custom control macro.
Note
Buttons with an asterisk ( * ) next to them in the list are already
programmed, however, they can be edited. Refer to the section
“
Editing Custom Control Macros ” on page 8–47 for details.
Note
You can record Relative Custom Controls instead of a normal
Custom Control. Refer to the section “ Relative Custom Controls ” on
page 8–16 for more information.