Ross Synergy 2 SD, Installation Manual

Page: 183 / 414

Synergy Series Installation Guide (v18) Custom Control Basics • 8–7
Custom Control Banks
Before programming the actual Custom Control buttons themselves, you must determine whether or
not you want to enable custom control “ Banks .” This feature effectively multiplies the total number
of custom control buttons that you have available.
Two types of banks are available: Normal and Audio . Normal banks are for storing normal custom
controls dealing with typical switcher video functions. Audio banks are used when custom controls
are created for use when the switcher is in Audio Custom Control mode, and remotely operates an
audio mixing board through the PGM and PST bus crosspoints. Refer to Chapter 11 “
Audio Mixers ”
for more information.
Up to eight banks can be enabled, and you can select any of the available custom control buttons on
which to place the bank buttons themselves. Each bank stores a separate set of custom controls.
Custom Control Bank Setup
Use the following procedure to set up Custom Control Banks:
1. Navigate to the Custom Controls Menu as follows:
• Press
HOME B MORE B Setup B Installation B MORE B Custom
Controls
.
2. Press
Setup Banks
to display the Bank Setup Menu .
Custom Controls — Bank Setup Menu
3. Assign a Bank to a Custom Control Button as follows:
• Use the Bank knob to select the desired bank that you wish to enable (from 1 to 8 ).
• Use the
Button
knob to select the desired custom control button that you want to
assign as the bank. If you need to disable a bank, select
NONE
.
Note
It is possible to record a custom control macro to a button that is
assigned as a bank button. However, this is only useful for audio
functions, as there is no means by which you could access a regular
custom control macro assigned to a bank button.
Note As you rotate the Bank and Button knobs, the Custom Control
Buttons will light, indicating the selected button on the control panel.