Ross Synergy 2 SD, Installation Manual

Page: 175 / 414

Synergy Series Installation Guide (v18) Basic Communications Setup • 7–19
DSK 3/4 (CDK-111A-M) Communications Setup
The DSK 3/4 Communication Setup procedure allows you to set up communications with the
CDK-111A-M Downstream Keyers. Once the procedure is completed, you will have full functionality
of an additional one or two DSK 3/4s on your Synergy switcher.
Use the following procedure to set up communications with a CDK-111A-M in Downstream Keyer
mode:
1. Ensure that the CDK-111A-M boards are installed. If not, please refer to the section
section “ DSK 3/4 (CDK-111A-M) Cabling ” on page 3–9 and the section “ DSK 3/4
(CDK-111A-M) Cabling ” on page 3–9.
2. Navigate to the Communications Menu 1-2 as follows:
• Press HOME B MORE B Setup B Installation B Communications .
3. Press Type to display the Type Menu .
Communications — Type Menu
4. Assign a Peripheral port to the DSK as follows:
• Use the Com Port knob to select the peripheral port ( PERIPH1 or PERIPH2 ) on
the Synergy frame that is connected to the CDK-111A-M.
• Use the Device knob to select the DSK (External Downstream Keyer) device.
5. Press Select Device to display the Select Device Menu .
Communications — Select Device Menu
6. Select the DSK you want to assign to the peripheral port as follows:
• Use the Com Port knob to select the peripheral port you want to assign a specific
DSK to.