Ross Synergy 2 SD, Installation Manual

Page: 152 / 414

6–20 • BNC Configuration and Check Synergy Series Installation Guide (v18)
Checking Inputs
At this point in the installation process, ensure that you have performed the following tasks for each
BNC input to your Synergy switcher:
• Named the input
• Set up its BNC type
• Set up its tally
• Set up its alpha parameters (if the input is an alpha signal)
• Set up its auto key association (if the input is an alpha signal)
• Set up its control panel button mapping
Use the following procedure to check your inputs:
1. Press HOME to exit the installation menus, and return to the Main Menu 1-2 .
2. When the “ Installation Warning ” menu appears, press Confirm to accept all changes.
3. Ensure that the program monitor is connected to the MAIN PGM output connector (on
the rear of the chassis).
4. Ensure that each source device connected to the switcher is putting out a signal.
5. Using your “ Input Worksheet ” as a guide, press each control panel button on the PGM
bus, starting with crosspoint 1. Verify that each signal is present on the crosspoint (as
mapped), and that it matches each connected signal as written on your worksheet.
6. For each shifted crosspoint, press and hold the SHIFT button, then press the desired
button on the PGM bus.
If any signal does not match, check your “ Input Worksheet ” against the settings that you made on the
Panel Button Setup Menu .
Operating
Tip
You can also double press the
SHIFT
button to have the MLE remain
in the shifted mode. Double pressing the
SHIFT
button again releases
the MLE from the shifted mode.